View Single Post
Old 07-09-2013, 09:31 AM
Rich859's Avatar
Rich859 Rich859 is offline
Dodge Ram Forum Senior Member
Join Date: Mar 2012
Location: Northern KY
Age: 22
Posts: 381
Gender: Male
Vehicle: 2009 Dodge Ram 1500 Crew Cab
Trim Level: Big Horn
Color: Black
Engine: 2009-2012 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 4
Rich859 is a jewel in the roughRich859 is a jewel in the roughRich859 is a jewel in the roughRich859 is a jewel in the rough

I have not posted a write up on how I installed them, but the only part that would be slightly difficult would be deciding where to place the button for the lights and then hiding its wires. All of the tubes for the underbody come with clamps that screw into the bottom on the vehicle and hold them in place, the wheel wells have screws that go through the plastic fenders and that holds those in place, and the interior lights come with screws but i just used 2 sided 3M stick tape and zipties. The install time for all of it was probably about 8 hours. Underneath you just have to make sure the wires aren't lose and aren't near anything that moves/ gets hot and you are set to go! I'll upload a few photos of where all of my buttons are placed to see if it can help give you an idea.
Bully's Performance Sponsored Truck

Too many mods to list. Full list can be found on my profile.
Reply With Quote