DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - DIY catch can installed with ball valve
View Single Post
Old 07-09-2013, 12:12 PM
Dodge Ram Forum Senior Member
Join Date: Feb 2013
Age: 35
Posts: 228
Gender: Male
Vehicle: 2013 Ram factory order
Trim Level: ST
Color: BLACK
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
HOTRODHARLEY is a jewel in the roughHOTRODHARLEY is a jewel in the roughHOTRODHARLEY is a jewel in the rough

Originally Posted by BlownGP View Post
Lol, sure if ya want. Driving the truck today to work. I did notice a nice throttle response and it seems to pull harder in the upper RPMs. To be honest though I haven't much time to get a feel for the truck. Just been driving back and forth to work with a little WOT every so often.

True as in what BP or Diablo Sport one sell? I guess since if you don't run one of those. Your not cool. lol

Most catch cans don't have mesh filter inside. So they must do something to sell them. This will at least be better than nothing..

I was looking at this one. Miget get later on since it mounts the same. Im going to see how mine works first

I get the whole install parts that are laying around... But why waste all that time on something that half ass works..? Do it right and do it once... Thats how I roll... Like a square wheel down the yellow brick road...
Belltech 3"/5" Lowering kit. Belltech Rear Swaybar, Flowmaster Y Pipe, Custom 4" Single Exhaust w/ 4" Race Magnaflow, 22" SRT10 Wheels, Moroso Catch Can, Undercover SE Tonneau Cover, Weathertech Techliner Bedliner, Diablosport Trinity w/ Hemifever Tune
Reply With Quote