View Single Post
  #5  
Old 08-09-2013, 02:16 PM
Warlock III Warlock III is offline
Former Senior Member
 
Join Date: Aug 2010
Location: Earth...DUH!
Posts: 7,867
Gender: Male
Vehicle: 95
Trim Level: Cloaking
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 11
Rep:1776
Warlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant futureWarlock III has a brilliant future
Send a message via AIM to Warlock III Send a message via Yahoo to Warlock III
Default

There is a metric equivalent I think it's like a 36mm but not sure right now.

The axle shafts for the 1500/2500 are usually only a difference of one has 3 and the other has 4 on the hub. They come apart the dame way though. I always recommend taking the axle nut off/loose while it's still on the ground. Otherwise you might have to stick a punch/chisel in the air slot (in the rotor) and get it to come around to the caliper, etc... to keep it from spinning.
Reply With Quote