View Single Post
  #1  
Old 08-10-2013, 05:13 PM
Eddy79 Eddy79 is offline
Dodge Ram Forum Newcomer
 
Join Date: Jun 2013
Location: Snoqualmie
Posts: 16
Gender: Male
Vehicle: 2013 RAM 2500
Engine: 2011-20?? 409ci (6.7L) Cummins Turbo Diesel 350hp 800lb/ft
Rep Power: 0
Rep:10
Eddy79 is on a distinguished road
Default 1st Pic of new 2500 and am I missing Trim?

Went to Idaho (Dave Smith) and picked up my new 2013 2500 Big Horn Diesel and drove back to Washington yesterday. This morning I put on wheel to wheel nerfs. Loved the ride home yesterday - my first big Truck!! They could not get the Nav activated - looks like I need to go and get a new radio.

after 300+ mile trip - need to wash it - but here is the 1st pic from this morning (after Nerf install). The pictures do not do it justice!

Now the question -- when installing the nerfs i see some holes (three sets of two small hols) on the body (see example of 1st set of holes in the 2nd photo) just above where i install the nerfs -- to me it looks like some black molding shoud go there -- and wondering if it was left off my truck. Anybody know if there is some molding that goes here (on the side bottom from wheel to wheel). If not - what are the holes for?
Attached Images
File Type: jpg 003 smaller.jpg (121.4 KB, 64 views)
File Type: jpg 004 smaller.jpg (105.0 KB, 76 views)
Reply With Quote
Sponsored links