View Single Post
  #33  
Old 08-11-2013, 04:22 PM
tguil tguil is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jan 2012
Location: Nebraska
Posts: 329
Gender: Male
Vehicle: 2012 Ram
Trim Level: Big Horn Quad Cab
Color: White
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:45
tguil is on a distinguished road
Default

No drill for the rear flaps if you choose to use only two out of the three mounting holes. I have mounted them using only the two holes and it works just fine. I filled the extra hole with black "plastic rubber".

For a tight fit on the front flaps, you need to drill the third hole. No problem at all doing this. You don't need to remove a wheel to do so. If you are worried about rust, don't worry. Put a dab of primer on the area after you drill the hole. The mounting screws are covered with a silicone seal that makes a tight rust proof bond.
__________________
2012 White Hemi 1500 QC, 4X4, Big Horn Edition, Protection Group, Luxury Group, 3.92 Anti-Spin, Mopar Bedliner, Mopar Tubular Side Steps, Mopar Molded Mud Guards, Access Roll Up Tonneau, Michelin LTX M/S 2's
Reply With Quote