View Single Post
  #2  
Old 08-25-2013, 02:57 PM
Magnum164 Magnum164 is offline
Dodge Ram Forum Newcomer
 
Join Date: Aug 2013
Posts: 4
Gender: Male
Vehicle: 2004 Dodge Ram 3500 4X4 DRW
Engine: 2004-2004 359ci (5.9L) Cummins ISB 600 24-Valve Diesel I6 325hp 600lb/ft
Rep Power: 0
Rep:10
Magnum164 is on a distinguished road
Default

OK, since there is nationwide shortage on SP3 pumps, I had two 33% mod's order from two different places and neither place had one. So both orders were canceled. Not even a good estimate on when backorders will be filled.

So, time to pull this pump out myself and see if any screws or loose.

Before I start, I have read all over the forums and net. I have read the cautions on the high pressure lines. But on most instructions on removing the CP3 there are no instructions on removing pressure before starting the removal.

Besides removing battery cables, is there any other precautions to take before removing pump? I assume the lines could still be under pressure even with truck off, then again its been off for a week. I am sure the lines have leaked down.
Reply With Quote