View Single Post
  #3  
Old 08-30-2013, 08:21 AM
Kamanhart's Avatar
Kamanhart Kamanhart is offline
Dodge Ram Forum Senior Member
 
Join Date: May 2013
Location: Peoria, Il
Age: 22
Posts: 1,151
Gender: Male
Vehicle: 2005 Dodge Ram 1500
Trim Level: SLT
Color: Silver
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 5
Rep:1049
Kamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud ofKamanhart has much to be proud of
Default

Well i got the header in and while taking out the manifolds i found the annoy broken manifold bolt that was causing the leak. The quality of build on the headers was about 6 times better than i expected everything was was excellently tig welded together and fit up perfectly to the truck. there was 2 low points for this headers though, i think they sent me the wrong cross over pipe that run from the drivers side header behind the transfer case, it was 2 inches short to get around the transfer case so i had to cut it and weld in a 2 inch stainless extension, also on that same pipe the rear o2 sensor is is point towards the outside of the exhaust making it really weird angle to get at, but i cut the pipe spun it around to the correct position and every thing is working beautifully.
Attached Images
File Type: jpg 20130821_170845_Richtone(HDR).jpg (26.3 KB, 18 views)
File Type: jpg 20130824_000051.jpg (22.9 KB, 14 views)
File Type: jpg 20130824_132228.jpg (24.0 KB, 16 views)
File Type: jpg 20130824_132240.jpg (22.4 KB, 13 views)
Reply With Quote