View Single Post
  #2  
Old 09-02-2013, 02:15 PM
69beeguy 69beeguy is offline
Dodge Ram Forum Newcomer
 
Join Date: Jul 2010
Location: st louis park, mn
Age: 44
Posts: 17
Gender: Male
Engine: 1994-1997 360ci (5.9L) Magnum V8 230hp
Rep Power: 0
Rep:10
69beeguy is on a distinguished road
Send a message via Yahoo to 69beeguy
Default everything

hey,
i have been looking into this for a project i would like to start. between viper and ram V-10's virtually everything is different. however, if you are looking into V-10 mods, think 5.9 magnum plus 2 cylinders. the 8.0 has a larger stroke than the 5.9 and the bottom end is a little different too. but rods and pistons are the same. i have been looking into 4.0 jeep con rods. they are 100g lighter, but much stronger. and there is a ton of them out there. they also have smaller rod journals, but same width. this way, you can offset grind the crank and get close to 500 cubes depending on overbore. the 8.0 has a 8.4:1 compression ratio. i do not physically have one yet to tear apart, but this should bring you close to zero deck. i am looking at picking one up here soon. i will have to beef up my engine stand because the 8.0 is 800lbs+.

jim
Reply With Quote