Originally Posted by Connman67
It is my understanding the holes are already on the bottom plates, all you need to do is insert the studs into the airbags. Can TLC confirm this? - Thank you
for the driver side it will line up fine, but for the passenger side you will need to make 2 holes 1/2" in size (just to be sure your stud fits in nice) and at an offset of about 1/2", then when you re-install the bottom plate, you will need to aligne it up, if you loosen the bolts that hold the bag to the top part you can easily wiggle it into place, then tighten it all up you should be good to go. I did my hole setup on the passenger side today.