Well grasshopper- please sit down and breathe deeply while I impart the wisdom of the ages.
I can't speak with any authority on a 2010 but on my 2013 I did the following:
pop the hood
shine a flashlight down the opening where the hood latch is
look for the 6 little plastic retaining tabs
reach arm down the rabbit hole and work the tabs open.
At this point it should have popped off.... but there was a postage stamp size of 3M tape holding it tight.
wiggle that and pops right off.
that said- you can plastidip it right in place- I did that on the tail emblem and it was a simple tape job.
Vararam Air Grabber, Vararam Power Chamber, 87mm TB, Diablo Tuner with HemiFever 91 tune, Magnaflow Muffler, Boss 338 22 x 9.5, Toyo Proxy 305 45 R22, GroundForce 2/3