View Single Post
  #3  
Old 09-09-2013, 08:13 AM
Excoastie's Avatar
Excoastie Excoastie is offline
Dodge Ram Forum Senior Member!

 
Join Date: Aug 2008
Location: Bossier City, LA
Age: 42
Posts: 3,445
Gender: Male
Vehicle: 2014 VW Jetta GLI
Color: Metalic Black
Rep Power: 10
Rep:1358
Excoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud ofExcoastie has much to be proud of
Default

Quote:
Originally Posted by pstern View Post
I also understand that the tailgate badge will leave 3 alignment holes if left removed, but can I fit a the small badge in its place that comes on the big horn models?
Unfortunately no, this will probably not be possible. I say this, because the rear emblem is recessed within the tailgate or the entire size of the rear emblem.

The smaller badge may cover up the alignment holes, but I doubt it would be big enough to cover the entire recession.

Have you considered going with the Ram Eyes, rather than just removing the rear emblem? It makes it (arguably) sort of functional at that point.

Below is a link to the thread that I started when I did my Ram Eyes
http://www.ramforumz.com/showthread....highlight=eyes

Good luck

Exco
__________________
Oracle Interior LEDs, EGR Vent Visors, Ram eyes, Husky Liner Splash Guards, R/T Badges Front and Rear, LED Light Bar, Stubby Radio Antenna, Custom Shift Knob, ARE LS II bed cover, Bed Rug, Flowmaster 50 series HD, SilverStar Ultra low beams, K&N drop in filter, MOPAR sill guards, Smitty Built nerf bars, 24% tint on the front.
Bill
Reply With Quote