View Single Post
  #15  
Old 09-10-2013, 10:51 AM
DAA DAA is offline
Dodge Ram Forum Senior Member!
 
Join Date: Aug 2012
Location: Utah
Posts: 467
Gender: Male
Vehicle: 2013 1500, CC/6'4", Hemi/8 spd
Trim Level: Longhorn
Color: Flame Red
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 2
Rep:352
DAA is just really niceDAA is just really niceDAA is just really niceDAA is just really nice
Default

Quote:
Originally Posted by JsonR View Post
I am going to order one of these today. It is the only possible solution I have found so far.... Scroll down to the pigtail tap.

http://www.tessco.com/products/displ...bgroupId=95152

I just took a regular fuse tap and did a little trimming and bending on it with dikes and needle nose. Took about 30 seconds to make it fit/work just fine in the '13 fuse panel.

There is a fuse for the rear 12V outlet that has two position provisions. Moving it makes the rear 12V outlet constant hot instead of keyed. Moving it also leaves a known ignition-on hot slot open in the fuse panel - that's where I put the tap after a few seconds massaging it into the smaller required shape.

Easy-easy. Cheap-cheap.

- DAA
Reply With Quote