View Single Post
  #10  
Old 09-17-2013, 05:43 AM
tonyhon tonyhon is offline
Dodge Ram Forum Newcomer
 
Join Date: Jun 2012
Age: 37
Posts: 7
Gender: Male
Vehicle: 2012 Dodge Ram 1500
Rep Power: 0
Rep:10
tonyhon is on a distinguished road
Default

Quote:
Originally Posted by Bix View Post
You say you wired to the "signal lights power" I think you meant parking lights yes? unless you've done a daytime running light conversion there.....

Did you add a resistor on the turn signal circuit or replace the flasher. I'm not even sure the flasher is an external unit on the '12. Trying to figure that out.....

I like the box lighting and underhood.

bix
Hum, not sure how to call it, it's the yellow bulb that I connected to. When the car start, the signal light lighted up all the time, and it flash when I use the turn signal. So I connected the LED to the this light's power wire that turn it on all the time, but when it's doing the signalling , it won't affect my LED, as the turn signal is controlled by a third wire on the same bulb.


Yes I did use load resistor, for both front and rear turn signal, so used 4 resistor. The front 2 I used this :
http://www.superbrightleds.com/morei...istor/191/832/

Used this for the rear 2 :
http://www.superbrightleds.com/morei...r-kit/190/831/

It was hyper flashing when I first install it without this resistor. Just make sure to mount it to metal without any plastic or wire touching it, it gets pretty hot.
Reply With Quote