View Single Post
  #10  
Old 09-22-2013, 03:03 PM
Jhouse's Avatar
Jhouse Jhouse is online now
Dodge Ram Forum Senior Member
 
Join Date: May 2012
Location: Pittsburgh
Posts: 484
Gender: Male
Vehicle: 2014 ram
Trim Level: Sport
Color: blue streak pearl
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 4
Rep:163
Jhouse has a spectacular aura aboutJhouse has a spectacular aura about
Default

You'd probaly have to open the wheel to check. To do that u need to first disconnect battery(very important). Remove the lower knee panel. 1 screw on each side then it pops out. Then 3 t20 torx screws under the colomn shroud. Top lifts off bottom u gotta wiggle out around tilt lever. Next is airbag removal. Make sure battery had been disconnected for 30 min. Put a mirror at your guage cluster as u have to work on the back of wheel. Theres 3 u shaped metal clips at 2 6 and 10 oclock. To remove them slide a flat screwdriver under them and twist it so they release. Theres two wire harnesses that connect the air bag. Mark which goes where and then remove. Then theres 4 screws in front and 4 in back that hold the bezel on. Remove them and pull the bezel out. Then you can see what u need to
__________________
K&n cai, bt catch can,moes 87mm throttle body,flowmaster super 44,20% tint front 15% rear,egr vent guards, black weatherguard toolbox, debadged,tinted tails,retroshop hid's 6000k in fogs and lows, custom mopar badges
Reply With Quote