Thread: Misfire problem
View Single Post
  #6  
Old 10-04-2013, 08:57 AM
tjbiker031's Avatar
tjbiker031 tjbiker031 is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2011
Location: Bradenton, FL
Age: 30
Posts: 307
Gender: Male
Vehicle: 2002 Dodge Ram
Trim Level: SLT - Quad Cab
Color: Graphite Metalic
Engine: 2002-2007 287ci (4.7L) PowerTech V8 235hp 295lb/ft
Rep Power: 4
Rep:118
tjbiker031 will become famous soon enoughtjbiker031 will become famous soon enough
Default

P0300 Diagnostic Code - Random Misfire



Technical Description

Random/Multiple Cylinder Misfire Detected
What does that mean?

Basically this means that the the car's computer has detected that not all of the engine's cylinders are firing properly.
A P0300 diagnostic code indicates a random or multiple misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Unfortunately, a P0300 doesn't tell you specifically which cylinder(s) is/are mis-firing, nor why.
Symptoms


Symptoms may include:
  • the engine may be harder to start,
  • the engine may stumble / stumble, and/or hesitate
  • other symptoms may also be present
Causes


A code P0300 may mean that one or more of the following has happened:
  • Faulty spark plugs or wires,
  • Faulty coil (pack) ,
  • Faulty oxygen sensor(s),
  • Faulty fuel injector(s) ,
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Stuck/blocked EGR valve / passages
  • Faulty camshaft position sensor
  • Defective computer
Possible Solutions

If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.
Random misfires that jump around from one cylinder to another (read: P030x codes) also will set a P0300 code. The underlying cause is often a lean fuel condition, which may be due to a vacuum leak in the intake manifold or unmetered air getting past the airflow sensor, or an EGR valve that is stuck open.
Other P0300 Reading
__________________
Show your thanks with the REP icon.

Get your Factory Manuals here!! <link fixed>

Last edited by tjbiker031; 10-04-2013 at 09:02 AM.
Reply With Quote