View Single Post
  #324  
Old 11-11-2013, 07:01 PM
kevinhann kevinhann is offline
Dodge Ram Forum Member
 
Join Date: Feb 2013
Location: DFW Texas
Age: 30
Posts: 50
Gender: Male
Vehicle: 2012 ram 1500
Trim Level: slt
Color: black
Engine: 2008-20?? 287ci (4.7L) PowerTech V8 310hp 330lb/ft
Rep Power: 0
Rep:18
kevinhann is on a distinguished road
Default

Quote:
Originally Posted by BigSilver View Post
I am going to install the factory brake trailer module in my 2012/ 1500 Tradesman with the A plug (no B plug). I do not have the EVIC. I was wondering if I could hook up the B3 Terminal, Fused Ignition Run/Start Control Output, Circuit F943 and leave the B1 and B2 CAN C Bus terminals empty. My understanding is that the CAN Bus terminals are only necessary for EVIC display.
I can confirm that if you give power to the (run/start pin) then it will work.
I just installed mine with connector A no connector b and it worked just fine. I later went to a junk yard and found a truck with one and took the pigtail. had the dealer activate the sales code along with my remote start. but yes it works with only the power wire attached Just splice into the pink wire with the light green stripe in the main dash harness that goes to the main 43 pin dash plug next to the brake pedal
Reply With Quote