View Single Post
  #329  
Old 11-16-2013, 06:20 PM
BigSilver's Avatar
BigSilver BigSilver is offline
Dodge Ram Forum Newcomer
 
Join Date: Aug 2012
Location: Texas
Age: 45
Posts: 12
Gender: Male
Vehicle: 2012 Ram
Trim Level: Tradesman
Color: Metallic Silver
Engine: 2008-20?? 287ci (4.7L) PowerTech V8 310hp 330lb/ft
Rep Power: 0
Rep:10
BigSilver is on a distinguished road
Default

kevinhann, thanks for the response. Because of your post I decided to go and hunt the pick-a-parts to see what I could find. I was able to find and buy an ITBM and gray/black bezel out of a 2011 3500 dually for $65. Bought three #8 x 5/8 trim panel screws from the hardware store to secure bezel to module and to secure rear of module to dash support . Everything came apart just like Netman66 post described. Installed ITBM and bezel plugged in the large "A" plug (no "B" plug, just spliced into the pink/greenwire and hooked up to B3). Hooked up to my neighbors 21ft Jayco travel trailer and went on a 20 mile test run. Worked great w/o the CAN + - wires. So if you have an ST or Tradesman w/o EVIC there is no reason to worry about the CAN + - wires.

Last edited by BigSilver; 11-16-2013 at 06:24 PM.
Reply With Quote