View Single Post
  #3  
Old 11-22-2013, 07:23 AM
adventurer's Avatar
adventurer adventurer is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jan 2011
Location: Amman-Jordan
Posts: 173
Gender: Male
Vehicle: 2010 Ram and 2006 Ram Hemi
Trim Level: 4x4 SLT and4X4 SPORT
Color: Silver , Flame Red
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:10
adventurer is on a distinguished road
Send a message via Skype™ to adventurer
Default

Quote:
Originally Posted by TransEngineer View Post
In 2011, we eliminated the OD solenoid from the trans solenoid module (which is inside the trans; it is part of the valve body assy). We now use the MS solenoid to control the OD clutch.

Your 2010 truck's PCM is still expecting it to have an OD solenoid. Since there is none there anymore (in the 2012 trans you installed), you get the P0760 OD Solenoid Circuit fault.

So you need to get a 2010-style solenoid, and install it into your trans. You could pull the old one out of your old trans I suppose. The 2010-style solenoid module has a white wiring connector on top of it, whereas the 2011+ style solenoid has a gray wiring connec tor. Swap the solenoid and you should be OK.
I ll do that tomorrow but what about the codes p0871(OD PRESSURE SWITCH RATIONALITY) and p0882(TCM POWER INPUT LOW) ?
__________________
2010- S&B CAI/87MM TB/HKS TB GW/OIL FILTER BREATHER/Y PIPE/PYPES VIOLATOR MUFFLER/HEMIFEVER TUNE.
06- MAGNAFLOW CAT-BACK/Y PIPE/TB SPACER/HKS-TB GW/MOPAR CAI/SUPERCHIPS/OIL BREATHER FILTER/JET 180 TSTAT/3.92 LSD


Reply With Quote