View Single Post
  #2  
Old 01-16-2010, 09:58 PM
RamTech's Avatar
RamTech RamTech is offline
Dodge Ram Forum Senior Member!

 
Join Date: Nov 2009
Location: Johnson City, TN
Age: 44
Posts: 12,120
Gender: Male
Vehicle: 2004 Dakota Club Cab 4X4
Trim Level: SXT
Color: Bright Silver
Engine: 2002-2008 226ci (3.7L) Magnum/PowerTech V6 215hp 235lb/ft
Rep Power: 15
Rep:1824
RamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant future
Default

REMOVAL

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and personal or fatal injury .

<A xmlns="http://www.w3.org/1999/xhtml"> 1.Disconnect and isolate the negative battery cable. 2.If equipped, remove the floor console. 3.Remove the cup holder if equipped. 4.On vehicles with a close out panel, remove the screws (3) and remove the close out panel (2).


<A xmlns="http://www.w3.org/1999/xhtml"> 5.Remove the screws (2).6.Using a trim stick C-4755 or equivalent, disengage the retainer clips that secure the instrument panel center bezel (1) to the instrument panel.


<A xmlns="http://www.w3.org/1999/xhtml"> 7.Disconnect the wire harness connectors (4) and remove the center bezel from the vehicle.
Reply With Quote