View Single Post
  #14  
Old 01-18-2010, 12:51 PM
Fuzznutts's Avatar
Fuzznutts Fuzznutts is offline
Dodge Ram Forum Newcomer
 
Join Date: Dec 2009
Location: Georgia
Posts: 21
Gender: Male
Vehicle: 2010 Dodge Ram 1500 QC
Trim Level: Bighorn Edition
Color: Mineral Grey
Engine: 2009-2010 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:25
Fuzznutts is on a distinguished road
Default

For the rear you remove 2 current screws that hold your fender well liner in, place the flap in place and reinstall the screws. That's about as easy as it gets!

For the front, you rotate your steering wheel to full lock, turn off the truck, remove 1 existing screw that holds the fender well liner in place, put the flap in position and start the existing screw back in its hole, add an additional screw with washer and nut that is provided with flaps in the next higher hole that is already there from the factory and tighten both. The kit includes one more set of hardware for each front if you choose to drill one additional hole towards the bottom of the liner and inboard about 4 inches to stiffen the flap. I did it and you still don't have to take the tire off using a regular 3/8" drill.

Let me know if you have any questions.

Fuzznutts
Reply With Quote