View Single Post
  #19  
Old 04-01-2010, 07:57 PM
sowardcustoms's Avatar
sowardcustoms sowardcustoms is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jan 2010
Location: Burleson,TX
Age: 38
Posts: 490
Gender: Male
Vehicle: 2013 Ram R/T
Trim Level: R/T
Color: Gray
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
Rep:145
sowardcustoms will become famous soon enoughsowardcustoms will become famous soon enough
Default

Quote:
Originally Posted by dustin72 View Post
I want to do the same thing on my 2010 RCSB 4x4. I want to lower the rear about 1.5" and have the ability to pull a trailer with no sagging. What brand/part number did you use for the rear bags? Was it a simple R&R of the factory springs?
There Airlift Dominator D2500 bags I ordered from suicidedoors I also used there bag plates 2 upper and 4 lower the extra ones for the lower plate where for the top of the factory spring mount so I would have something to bolt the top of the bag mount to and then measured and cut some tubing welded them to the plates and used all thread for the studs after all that yes it was pretty simple to swap the springs the factory springs will almost fall out if you jack the truck up all the way in the back.....
Reply With Quote