Thread: exhaust clamps
View Single Post
  #2  
Old 07-17-2010, 01:50 PM
erm
Guest
 
Posts: n/a
Default

The clamps can be re-used unless you have to cut them off to get them loose. That happens sometimes.

If the replacement muffler is the same length, you should probably be able to slip it right in. It might help to loosen the hangers to give you some wiggle room to slip it in. Don't forget to put them back in place!

Yes, you'll have to replace the resonator length with a short piece of pipe. You can pie cut the edges to slip it in and clamp it but I'd suggest you go to a shop and get it welded in or you may experience some leaks in this area.
Reply With Quote