View Single Post
Old 09-15-2010, 09:28 PM
ken99 ken99 is offline
Dodge Ram Forum Senior Member
Join Date: Jul 2010
Location: Montana
Posts: 107
Gender: Male
Vehicle: 2010 Ram 1500 Crew 4x4
Trim Level: SLT
Color: Austin Tan Pearl
Engine: 2009-2010 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
ken99 is on a distinguished road

Originally Posted by rick980 View Post
I could just put female spade connectors on the ends of my plug that goes into the big blue one and just plug them on separately on each connector.
I would make a set of jumpers that plug into the blue connector on one end and the ITBM on the other. Over the year, I've learned it is usually best not to cut off OEM harness connectors.

Then figure out the bus wires...maybe they are the same.
Like I said in the PDF I provided with post #37, it theory it should work.
Reply With Quote