Originally Posted by latitud
I have no doubt that welding this way will work, you will just fill the gaps with weld. I used clamps for future removal if necessary. I am only saying that the factory muffler for dual exhaust on a 2010 is 3" in and 2.25" dual out and that the tail pipes are 2.25". Also, unless you are welding in a 26" muffler to replace the stock one, you will need an extension pipe.
gotcha. I follow ya now.
I was getting a bit of confusion on my end as to why some folks are going with the 2.5 and others with 2.25. Makes sense now.