View Single Post
  #1  
Old 02-13-2011, 06:49 PM
sk8noregon's Avatar
sk8noregon sk8noregon is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2010
Location: Oregon
Age: 32
Posts: 2,111
Gender: Male
Vehicle: 2008 Dodge Ram
Trim Level: Big Horn
Color: Mineral Grey
Engine: 2008-???? 287ci (4.7L) PowerTech V8 310hp 330lb/ft
Rep Power: 6
Rep:637
sk8noregon is a name known to allsk8noregon is a name known to allsk8noregon is a name known to allsk8noregon is a name known to allsk8noregon is a name known to allsk8noregon is a name known to all
Default Finished another Mod !

Just finished installing a new K&N Air Intake. After all is said and done I think I would rate this kit about a 7 out of 10. It took longer than I anticipated. My exhaust was easier to install at about an hour less time. It does look good but there were a couple of things I did not like about it. #1 is where the air temp sensor gets drilled out in the tube, there is supposed to be a mark for the location, but there was not. So I had to guess off of the picture. #2, I was told the directions were in full color, they were not. Black and white with a couple pictures that were to dark to even see. #3, two of the hose clamps that you can see in the first picture were about a 1/2 inch short in length so I had to buy a couple new ones. Hose clamp for throttle body was fine. In the end i'm satisfied with it but hopefully Volant gets a kit done for the 08 4.7L soon as that is what I really want. Thank you.
Attached Images
File Type: jpg K&N 001.jpg (39.6 KB, 25 views)
File Type: jpg K&N 002.jpg (45.3 KB, 30 views)
__________________
"Rocky and Bullwinkle"
Join the "Mineral Gray Metallic Ramz Group" here !
Reply With Quote
Sponsored links