DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - Help!!No Heat!
Thread: Help!!No Heat!
View Single Post
Old 12-20-2008, 09:45 PM
MADDOG MADDOG is offline
Dodge Ram Forum Senior Member
Join Date: Jan 2012
Posts: 2,782
Gender: Male
Rep Power: 0
MADDOG is on a distinguished road

LOL Roadie...

I found one source for manuals...but they cost $11.99 to download. I didn't find any others so I went ahead and downloaded it.

The whole diverter valve and control box is one unit under the dash, straddling the center transmission hump.

Here's the instructions:

Removal (Ram Pickup - Front)
1) Disconnect negative battery cable. Drain cooling system.
In engine compartment, remove coolant hoses from heater core tubes.
Remove coolant overflow bottle.
2) Discharge A/C system, using approved refrigerant
recovery/recycling equipment. Disconnect refrigerant lines from
evaporator and plug or cover all openings in A/C system. Remove
instrument panel. See INSTRUMENT PANEL. Remove Powertrain Control
Module (PCM) and position aside. DO NOT disconnect 60-pin connector
from PCM.
3) Remove attaching nuts from studs on engine compartment
side of dash panel. Remove defrost duct. Disconnect electrical
connectors. Remove attaching nuts from studs in passenger compartment
side of dash panel. Remove A/C-heater assembly from vehicle. See
Fig. 5.
4) Place A/C-heater assembly upside-down on work bench.
Remove screw securing floor duct to bottom of A/C-heater assembly and
slide floor duct off of center heat duct adapter. Unsnap center heat
duct adapter from bottom of A/C-heater assembly housing. Remove screw
hidden behind adapter. Remove remaining screws and separate A/C-heater

Not a job I'd tackle...honest!
Reply With Quote