Thread: rotors
View Single Post
  #2  
Old 03-30-2011, 04:07 PM
RamTech's Avatar
RamTech RamTech is offline
Dodge Ram Forum Senior Member!

 
Join Date: Nov 2009
Location: Johnson City, TN
Age: 44
Posts: 12,120
Gender: Male
Vehicle: 2004 Dakota Club Cab 4X4
Trim Level: SXT
Color: Bright Silver
Engine: 2002-2008 226ci (3.7L) Magnum/PowerTech V6 215hp 235lb/ft
Rep Power: 14
Rep:1824
RamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant futureRamTech has a brilliant future
Default

REMOVAL
  1. Raise and support vehicle.
  2. Remove wheel and tire assembly.
  3. Remove hub extension mounting nuts and remove the extension from the rotor if equipped.
  4. Remove brake caliper.
  5. Remove the cotter pin and hub nut from the axle shaft.
  6. Disconnect the ABS wheel speed sensor wire from under the hood. Remove sensor wire from the frame and steering knuckle.
  7. Remove hub/bearing mounting bolts from inboard side of steering knuckle.
  8. Remove rotor hub/bearing assembly, brake shield and spacer from the steering knuckle NOTE: If rotor hub assembly will not come out of the knuckle, use Puller C-844 with extra Puller Leg C-884-1 to remove the remove the assembly.
  9. Press out the wheel studs/hub extension studs and separate the rotor from the hub.
Discard spec is 1.269 in for the LD and 1.521 for the HD brakes.
Reply With Quote