View Single Post
  #6  
Old 05-24-2011, 10:04 PM
ramvan2500's Avatar
ramvan2500 ramvan2500 is offline
Dodge Ram Forum Senior Member!
 
Join Date: Apr 2011
Location: Florida USA
Posts: 1,864
Gender: Male
Vehicle: 1995 Dodge Ram B2500 Van
Trim Level: SLT - 2500
Color: Deep Molten Pearl Coat, Silver, Grey
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 4
Rep:127
ramvan2500 will become famous soon enoughramvan2500 will become famous soon enough
Default

Quote:
Originally Posted by pred View Post
OK Looking for a MAP sensor as well as the distributer shaft sensor,
Now is there a ECM somewhere?
I dont mind tossing some $$s into the truck,
Peter
The ECM Is under the hood against the firewall. The connector for the scanner should be under the right knee bolster. I have a 1995 but had a 2003 and I know the 1996 is when the scan connector became avail. On the 1996 ram van it's on the left side. Anyway's you need to have the timing done I think. Have a vacuum and boost tester hooked up to test for bad timing etc...

Their is a bunch more that can cause these issues but you and I can only go through them one by one and take our time. But just go ever with me so I understand exactly what is going on in detail. Detail is important.
Reply With Quote