View Single Post
Old 05-25-2011, 08:26 PM
Mullett Man Mullett Man is offline
Dodge Ram Forum Newcomer
Join Date: Jan 2011
Posts: 6
Gender: Male
Vehicle: 2013 Ram 1500
Trim Level: SLT Bighorn
Color: White
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Mullett Man is on a distinguished road
Default Block of Foam fell into Blower Motor

Greetings, last I was here ya'll helped me get the recirc door swapped out without tearing the dash out. And I'm (still) grateful.

I have another question that I can't find the answer for. Today, with the blower motor running the truck shuddered and the motor sounded like it was impeded from spinning. A second later (before I could really react) it quit, and all was normal. This happened again within a few minutes, with the same result.

After getting back to the house I pulled the motor out and found foam stuck in between the ribs of the cage. Sticking an arm up the hole into the area behind the glove box I did find a lose piece of foam. Well, several pieces. But it appears it was once a single block. The grooves in the foam make me want to think it was insulating something.

Can anyone tell me where its from, and if it needs to be replaced? I'm afraid I am having mode door issues anyway, and will have to have this looked at in the near future. Pulling the dash out is way out of my league.

Any comments welcome! Thanks!
Reply With Quote
Sponsored links