View Single Post
  #12  
Old 06-11-2011, 09:49 AM
ricstone ricstone is offline
Dodge Ram Forum Newcomer
 
Join Date: Jun 2011
Location: South East Missouri
Posts: 9
Gender: Male
Vehicle: 2010 Ram 1500
Rep Power: 0
Rep:10
ricstone is on a distinguished road
Default

Quote:
Originally Posted by CHVYKLR View Post
I just mounted my Tekonsha in the factory location. It doesn't look as nice as the factory optioned one but I think it'll work. I removed the piece of trim then used a dremel, file and utility knife to cut out the back of the panel. The controler fits so good/tight I didn't have to drill any holes and the harness plugged right in. It sticks out about 1.5"s...just enough so I can use the buttons/controls but not so much where I hit my knee on it b/c of how high the location is.
How did you get that trim piece of?? Wanting ti do the same setup. Have the same controller. Thanks
ric
Reply With Quote