View Single Post
  #2  
Old 06-25-2011, 12:50 PM
erm
Guest
 
Posts: n/a
Default

Yup...it can be done but you'll have to sort out the wiring harness and make a few splices I'm sure. Also, I assume you are talking the entire dash and not just the top or instrument portion? Because the top and bottom halves will not match up.

Lastly, before you jump in too far, check the measurements of the steering wheel length from the firewall to the fact of the wheel and the location horizontally and vertically of the steering shaft penetration.
Reply With Quote