Thread: Leather seats
View Single Post
  #19  
Old 07-07-2011, 03:09 AM
Truckcave's Avatar
Truckcave Truckcave is offline
Dodge Ram Forum Newcomer
 
Join Date: Jun 2011
Location: Pensacola
Posts: 9
Gender: Male
Vehicle: 2011 Dodge Ram
Trim Level: Big Horn
Color: Rugged Brown
Engine: 2009-???? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:11
Truckcave is on a distinguished road
Default

Just had my Katzkin installed by the dealer in my '11 Quad cab. Overall, its looks great, but there's a few things I'm unhappy with.

I have the bench front, not the console. The leather on both front bucket seats, toward the rear part that you sit on, is kind of of loose, like it needs to be tightened down/pulled to the back and under. The leather piece that wraps up around the folddown/middle seat console on the drivers side pulls right out of its groove when I have it open, and its kinda folded when you look at it from the side because it doesn't align around the hinge properly (for the folding part). Also, the VELCRO where the cover attaches in between the drivers and middle seat (next to the seatbelt receiver) is just loose and flopping in the crevice.

Like I said, quality and overall look is fantastic, but as far as installation goes, I'm taking it into the shop tomorrow where they did and seeing if they can tighten it up a bit.

Anyone else experience this?
Reply With Quote