View Single Post
  #1  
Old 07-12-2011, 11:15 PM
RamSki RamSki is offline
Dodge Ram Forum Newcomer
 
Join Date: Jun 2011
Location: Southern California
Posts: 2
Gender: Male
Vehicle: 2005 Dodge Ram 1500
Trim Level: SLT
Color: Blue
Engine: 2002-2007 287ci (4.7L) PowerTech V8 235hp 295lb/ft
Rep Power: 0
Rep:10
RamSki is on a distinguished road
Default Need help wiring new switch for new fog lamps!

2005 1500 Quad Cab that I bought about a month ago. Did not come with fogs. I ordered a Mopar packaged kit online that came with new bezels, frames, bulbs, wiring, and switch. Only no switch in the box. I called the seller and he shipped a new switch with no problem. I had already installed the lamps and wiring by the time the switch got here. The instruction sheet that came in the kit shows basically a small, round, three-wire toggle switch that you have to drill out a hole for and mount on the dash. The switch they sent me, however, is a Mopar replacement headlamp switch that includes the fog lamp control. With this switch you pull out/push in the headlamp switch when it's in one of the on positions to turn on/off the fog lamps.

The problem is that all of the six wire posts in the existing wiring harness that plugs into the headlamp assembly are occupied! The is no room for the new wires. It seems to me that the truck is pre-wired for the fog lamps, even though it didn't receive them or the controller switch when it was manufactured. So I have to splice in or plug in somewhere "downstream" from the switch but I can't figure out where. Any ideas? Anybody got a wiring diagram? Hope you guys can help!
Reply With Quote
Sponsored links