View Single Post
  #2  
Old 07-14-2011, 08:13 PM
ramvan2500's Avatar
ramvan2500 ramvan2500 is offline
Dodge Ram Forum Senior Member
 
Join Date: Apr 2011
Location: Florida USA
Posts: 1,917
Gender: Male
Vehicle: 1995 Dodge Ram B2500 Van
Trim Level: SLT - 2500
Color: Deep Molten Pearl Coat, Silver, Grey
Engine: 1994-2001 318ci (5.2L) Magnum V8 220hp
Rep Power: 5
Rep:128
ramvan2500 will become famous soon enoughramvan2500 will become famous soon enough
Default

Quote:
Originally Posted by sethprofitt View Post
I recently stripped my spyder gears out in my rearend while doing "tug a truck". I welded the spyder gears together but the welds broke after about a week. So i bought a spool to replace it but i'm having alot of trouble removing the old gears. I removed the bolt that goes into the center pin and beat the pin with a hammer and it wont budge. I'd appreciate all the help i can get.
Try beating it out from the other end if you still can't get it out then de-grease everything very well and heat up the metal around the pin this will cause it to expand a little then hit the pin with a hammer. Try heating the metal for about 15 minutes, be sure to spread the heat so don't focus the torch on one area.
Reply With Quote