View Single Post
Old 07-17-2011, 08:55 AM
skruface's Avatar
skruface skruface is offline
Dodge Ram Forum Member
Join Date: May 2011
Location: Canada
Age: 43
Posts: 66
Gender: Male
Vehicle: 2011 Dodge Ram 1500
Trim Level: ST
Color: Fire Red
Rep Power: 0
skruface is on a distinguished road

Originally Posted by Reddog170 View Post
Can you trim the covering back, notch the corner and glue the covering back on so you can regain the cup holder and prevent the speaker box from being accidentally hit? Shaun
It's covered in some kind of spray-on bed-liner-like material, so I guess I could always re-spray it, the problem is if I ground down that corner to where it should be, the box would only be 1/16th of an inch thick and would surely flex from the SPL. Conceivably, I could just cut the entire corner off at a 45 degree angle and put a new piece of MDF in there as he end plate, but that would further reduce the internal volume of the box, as well as a potential air seal issue if it's not perfectly square. So short answer is yes, I could, but it's more work than I want to do at the moment. I think I'll just enjoy it for a bit first.
Iron Cross HD Step review:
Reply With Quote