View Single Post
  #4  
Old 08-08-2011, 09:35 PM
baggs24v99 baggs24v99 is offline
Dodge Ram Forum Newcomer
 
Join Date: Aug 2011
Location: colorado
Age: 29
Posts: 7
Gender: Male
Vehicle: 1999 dodge ram diesel
Trim Level: lt
Color: silver with a purple bed I just got
Engine: 1999-2000 359ci (5.9L) Cummins ISB 24-Valve Diesel I6 235hp 460lb/ft (manual)
Rep Power: 0
Rep:10
baggs24v99 is on a distinguished road
Default

Quote:
Originally Posted by CloneSaw View Post
I have an '01 Dodge 3/4ton. The throw out bearing is going out and am thinking about putting a new clutch in while i have everything apart. Any opinions or suggestions on the best clutch for the dollar. I priced one at the parts store- Sach clutch @ $310.

Any ideas?

Thanks
Hey I put a new clutch and throw out bearing in my 99 cummins a few months ago and I found a really good deal from Beansdiesel for a south bend rally clutch that came with all the nessecary parts including the throw out bearing. I did a ton of research on the company and the clutch and it was really well liked. It has done very well in my truck and I have put it through a lot since its been in. The whole set up cost (if I remember correctly) right around or a little over $500 well worth the extra cost though. I have done some pulling that was not recommended even for the truck but that clutch performed amazingly. It may be something to look into.
Reply With Quote