View Single Post
Old 09-12-2011, 01:10 PM
Basher Basher is offline
Dodge Ram Forum Junior Member
Join Date: Feb 2011
Location: Seattle
Posts: 46
Gender: Male
Vehicle: 2006 Dodge Ram MegaCab
Trim Level: SLT
Color: Black
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 0
Basher is on a distinguished road
Default Wiring a 7-pin into an 07 1500

Hey Guys,

I am trying to figure out how to wire up the brake controller and power feed at the bumper of my 07 MegaCab. I have searched her and the web and the eTrailer videos, but I cant figure out where the wire leads are to hook up at the bumper.

So far I have the 7-pin plug mounted in the bumper and the factory 4-flat plug goes right into it, leaving the grounding wire, power feed, and brake wire left to be hooked up.

So where are the factory wires for these leads???? I have pulled the loom off the wiring harness at the back of the truck but it isnt obvious and I cannot find anything online.

Thanks for any help

2006 MegaCab 2wd on 22's
1956 1/2ton Dodge: 318/904 3.23's: Chopped Dropped and Shaved
Reply With Quote
Sponsored links