Hey guys heres a little info any input would be awsome. I have just recently replaced most of the front end on my truck. Upper lower ball joints, inner outer tie rods , pitman arm and idler arm. After doing this I noticed my truck pulled to the right on braking... Then I had a shop install my 2.5 in level kit and shocks and align it ( because the sent me the wrong parts the first time when i had her apart!
) and still it was pulling to the right with braking the harder the brakeing the worse it gets.... So i checked the caliper that i recently replaced to find it was sticking again.. so i replaced that and then the rear wheel cylinder on the same side that was bad so after all this my truck is still pulling to the right on brakeing... Any ideas this one has me stumped!!