View Single Post
  #11  
Old 09-19-2011, 07:05 PM
chambers chambers is offline
Dodge Ram Forum Senior Member!
 
Join Date: Oct 2010
Location: VA
Posts: 95
Gender: Male
Vehicle: 2004 Dodge Ram 1500
Trim Level: ST
Color: Silver
Engine: 2002-2008 226ci (3.7L) Magnum/PowerTech V6 215hp 235lb/ft
Rep Power: 0
Rep:29
chambers is on a distinguished road
Default

Quote:
Originally Posted by deervalley View Post
Chambers,
I saw your dyno run on that link you provided but am a little confused. Were those numbers ran with all your mods, or just the ones listed under each run?
All of performance mods were done when I dyno'd. The only thing changing was the tune, the graphs compare stock and jet chip, and stock and hemifever's tune. The peak hp and torque for the hemifever tune might be a little bit higher than the graph shows b/c we were doing 4th gear pulls for that and hit the speed limiter (note the dropoff past 5k rpm). I wasn't aware this was happening until after I got home and really looked over the graphs. The stock vs. jet chip runs were in third gear so they didn't hit the limiter and showed the true peak power for that gear and tune. I was trying to run in 4th b/c I read you're supposed have the tranny gear w/ a 1.0 ratio which was 4th w/ the nv3500.
Reply With Quote