View Single Post
  #1  
Old 09-23-2011, 12:35 PM
ironchef2011's Avatar
ironchef2011 ironchef2011 is offline
Dodge Ram Forum Member
 
Join Date: Aug 2011
Location: Orange County, NY
Posts: 456
Gender: Male
Vehicle: 2012 R/T
Trim Level: R/T
Color: Black
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 4
Rep:120
ironchef2011 will become famous soon enoughironchef2011 will become famous soon enough
Default 4TH Gen: Stock Alpine Door Speaker Specs

Here are the detailed measurements of the stock Alpine door speakers:

Door: 6x9" speakers with a 2.0 ohm rating (2 1/2" depth)

The front speakers have a midrange only, crossover affected frequency range. No high frequencies.

The rear speakers have a full range signal.

For removal of the speakers, the door panel has to be removed. This is easily accomplished by:
  • Prying open the little circle inside of the door handle and removing the phillips head screw. Also gently pry out the plastic handle cover.
  • Then remove the plastic screws and retainers from around the door panel with a Torx 20 tool.
  • Remove the sail panel above the door panel, by the mirror. Just gently pry as it's held in by clips only.
  • Gently pull the door panel outwards and then up. Before the panel will come off, release the wiring harness from underneath the switch panel while it's still in the panel. There's no need to remove it. Finally, lift the panel over the door lock pull and set aside.

The speaker is held in place by four bolts which can be removed with a 3/16" socket.

For ease of replacement, use Crutchfield harness #12071050 on all of these speakers.

http://www.crutchfield.com/p_1207105...s.html?tp=3097
Attached Images
File Type: jpg Alpine_Door_Speaker-0001.jpg (122.7 KB, 289 views)
File Type: jpg Alpine_Door_Speaker-0002.jpg (119.8 KB, 228 views)
__________________
2012 R/T 392

Last edited by ironchef2011; 09-23-2011 at 12:59 PM.
Reply With Quote
Sponsored links