DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - S & B intake filter wash
View Single Post
Old 10-15-2011, 10:54 PM
Posts: n/a

You'll want the S&B part number 88-0007 cleaning kit.

Here's how the cleaning process goes:

1. Remove and clean

Clean sealing area of filter and filter housing with a clean soft rag. Share or lightly tap the filter on a hard surface to remove and loosen large particles and debris. A soft brush may be used to loosen large particles of debris or bugs. Make note of wich side the filter has trapped the dirt. Use S&B's Filter Cleaner to clean the filter.
2. Fill applicator bottle

Rotate the Squeeze Bottle of Oil with the cap facing downward. Make note of your starting point on the measurement guage to make sure that the proper amount of oil is dispensed. When reoiling a filter, it is critical to place the oil on the side where the dirt will accumulate. Using the applicator bottle, place a drop of oil on the peak of each pleat where it meets urethane (rubber).
3. Allow oil to bleed

After allowing the oil to bleed for 20-30 minutes, inspect the fitler for any white areas wher ethe oil did not cover. With the remaining oil in the Applicator apply a small amount of oil to those white areas. Applying the correct amount of oil (+5 grams) is critical to proper performance of the filter. DO NOT over oil your filter.

As far as your exhaust, normally aftermarket mufflers are louder than stock mufflers. Also, most have the name of the mfgr stamped on them.
Reply With Quote