View Single Post
  #1  
Old 10-17-2011, 12:28 PM
chuckie chuckie is offline
Dodge Ram Forum Senior Member!
 
Join Date: Jan 2011
Location: san diego
Posts: 174
Gender: Male
Vehicle: 2011
Trim Level: r/t
Color: silver
Engine: 2009-2010 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 4
Rep:102
chuckie will become famous soon enoughchuckie will become famous soon enough
Default 2011 r/t custom intake tube

Since no one makes an intake tube only for 2009 and newer I made my own:



Parts needed:
airaid u-build-it kit 100-350 3 1/2"
http://www.airaid.com/ProductDetail....ductID=100-350
It is a big loop of plastic pipe with various angles, I used a 45 degree
at the airbox and a 90 degree at the throttle body. Cuts real clean with
power mitre saw.

Silicine hose couplers from HPS
http://www.hps-siliconehoses.com/
I used coupler HTSC-350 at the throttle body and in the center junction.
At the airbox I used flex/hump coupler HTSHC-350.
6 stainless T-clamps needed

The rubber grommet for the air temp sensor: OMAR-2761
http://search.cableorganizer.com/ind...0&Ntk=products
I used a #4 unibit to drill the hole. Run the bit all the way through to make
a clean 7/8" hole. Regular drill bits will not make a good hole

Total cost around $200

Very happy with results, running k&N drop-in and fastman throttle body
Reply With Quote
Sponsored links