View Single Post
  #4  
Old 10-17-2011, 10:02 PM
spadgitt spadgitt is offline
Dodge Ram Forum Newcomer
 
Join Date: Sep 2011
Location: Birmingham, AL
Posts: 16
Gender: Male
Vehicle: 2011 Dodge Ram 1500 Quad Cab
Trim Level: Sport
Color: Deep Water Blue Pearl
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:10
spadgitt is on a distinguished road
Default

Thanks Moparornocar (BTW, great name!), that's a great idea. I didn't even think about the steering wheel stuff. Good to know it just pops right out.

Scipione, that 3M Di-noc stuff is amazing. Just remember, HEAT is your friend. I used a heat gun. I'm not sure if a hair dryer will get hot enough. Just when you think you have totally screwed a piece up, throw some heat to it and it's like magic. Patience is also rewarded. Oh, and don't do what I did and start to cut some of the holes out before you have it laid down nice and smooth. I thought it would help to cut on it a little where a hole was going to be to give a little bit of "wiggle room". Bad idea. Leave the sheet whole until you have it where you want it, THEN cut the holes.....

Scott P.
Reply With Quote