View Single Post
Old 10-24-2011, 04:50 PM
xtremedurb00's Avatar
xtremedurb00 xtremedurb00 is offline
Dodge Ram Forum Member

Join Date: Feb 2011
Location: Hillsboro, IL
Age: 30
Posts: 71
Gender: Male
Vehicle: 2007 Dodge Ram 1500 QC BH
Trim Level: Big Horn
Color: Black
Engine: 2003-2008 345ci (5.7L) Hemi V8 345hp 375lb/ft
Rep Power: 0
xtremedurb00 is on a distinguished road
Default 12" Puller/Pusher E Fan Install

I got this 12" e fan out out of a 94' Ford Thunderbird SC. It was used for the intercooler. After figuring out how to mount it, I decided to put it in front of the tranny cooler.
You can't see it from here but, I had to trim the edge of the shroud to get it to fit over the oil cooler
Power, source and ground wire all ran together
Ground wire for my switch and e fan along with the source wire
Source, ground and power wires ran to the switch through the rubber boot on the driver side firewall

Wires that come through the firewall and ran to the switch
That plastic piece became useful for something
All together it took me about 3 hours to do.
20% Tint,Magnaflow Y-Pipe & Exhaust,Jet 180 TStat,NGK V-Power,TB Ground,EFan,Superchips 3865, K&N 57

Last edited by xtremedurb00; 10-25-2011 at 01:55 PM.
Reply With Quote
Sponsored links