View Single Post
  #10  
Old 10-25-2011, 08:01 AM
Rkeytek's Avatar
Rkeytek Rkeytek is offline
Dodge Ram Forum Senior Member!
 
Join Date: Dec 2010
Location: LI, NY
Age: 33
Posts: 277
Gender: Male
Vehicle: 2011 ram 1500
Trim Level: Big Horn
Color: White
Rep Power: 4
Rep:210
Rkeytek has a spectacular aura aboutRkeytek has a spectacular aura aboutRkeytek has a spectacular aura about
Default

Here are the ones I'm almost finished making gotta do some grinding and send to powdercoat. I can't find my old thread either...It might have been in my vendor section and deleted when I stopped that. Its been crazy and I haven't worked on them much until this week







^^ These have since had extra support welded between the two horizontal to help take lateral forces. Hey hook over the frame and will support my weight with out bolting into the frame



The tube is 2x6 1/8" wall and the center bracket is 3/16" cut and welded and the front and rear are 1/4" all bolt to the frame using existing holes. I did have to drill 2 holes per side on the inside of the frame so i can send a bolt right thru.
Each bracket actually extend into the tube the full 6" width for extra support

Last edited by Rkeytek; 10-25-2011 at 08:05 AM.
Reply With Quote