DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - Upper Glove box?
View Single Post
Old 01-17-2012, 11:59 AM
Al E. Gator's Avatar
Al E. Gator Al E. Gator is offline
Dodge Ram Forum Senior Member
Join Date: Jan 2011
Location: Kathleen, GA
Age: 54
Posts: 219
Gender: Male
Vehicle: 2017 Ram 1500 Sport Night
Trim Level: ST
Color: Deep Water Blue Pearl
Rep Power: 0
Al E. Gator is on a distinguished road

From what I have been able to figure out on my 2011, it takes one screw and 5 minutes to put in the glove box. The hard part is finding one. So far I can't find a part number so that leaves junkyards as a source. The tray that is there now clips in and has one screw in the bottom. To take it out, open your lower glove box and remove it by pressing in on the sides so it drops down lower and comes right out. Looking up through the hole there is one screw near the center of the the top tray that needs to come out. After taking the screw out the tray pops right out. If you can find a complete upper box the install snhould be the reverse of the steps I just outlined.

Last edited by Al E. Gator; 01-17-2012 at 12:02 PM.
Reply With Quote