DODGE RAM FORUM - Ram Forums & Owners Club! - Ram Truck Forum - View Single Post - 2011 Ram Dash Switches (ram insert)
View Single Post
Old 01-21-2012, 07:55 PM
brguzz's Avatar
brguzz brguzz is offline
Dodge Ram Forum Senior Member
Join Date: Jul 2011
Location: Ontario
Age: 24
Posts: 135
Gender: Male
Vehicle: 2012 Ram 1500 Sport
Trim Level: Sport
Color: Bright White
Engine: 2009-???? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
brguzz is on a distinguished road

If you have a console you must first remove the chrome ring around the shifter by simply prying it up gently. Next under the rubber tray in the console (below the heater controls) there are 2 screws to remove. On the actual dash part, the top rubber pad where it says "ram" needs to be popped out and there are 2 torque screws under there, followed by one torque underneath the cover of the household plug. In order to access the plug torque open the flap and there is a little flat part at the bottom where a small flat head will fit into. Once this is done the cover pops right off. Then gently pry on each side of the dash section and it is held in by clips.

Best of luck
2012 White Ram Sport
Reply With Quote