View Single Post
Old 03-28-2012, 08:46 AM
Pyroboy5000's Avatar
Pyroboy5000 Pyroboy5000 is offline
Dodge Ram Forum Senior Member
Join Date: Feb 2012
Location: Blue Ridge, GA
Age: 21
Posts: 478
Gender: Male
Vehicle: 2010 Dodge Ram 1500
Trim Level: TRX
Color: Flame Red
Engine: 2009-2012 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Pyroboy5000 is on a distinguished road

Originally Posted by itshertruck View Post
SS4, so for all the LED's on/in your truck, you had to solder resistors on each of them? I am just trying to get clarification. Not trying to go through any extra work/$$ if I incidently screw up any bulbs. Thanks for the info as well.
no. not if you buy them from because those bulbs have the resistors inside of them. now if you were going to buy a box of single leds and find places to put them in your truck, you would need to wire a resistor to each individual led that you used.

also you would need an additional load resistor for your blinkers if you replaced them with leds, because your truck might give you a hyperflash/bulb out signal.
Confederate Ram TRX
Reply With Quote