View Single Post
  #39  
Old 03-29-2012, 07:49 PM
kdramman kdramman is offline
Dodge Ram Forum Newcomer
 
Join Date: Aug 2011
Location: Oklahoma
Posts: 28
Gender: Male
Vehicle: 2009 Ram Crew Cab 4x4
Trim Level: SLT
Color: Brilliant Black Crystal Pearl
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 0
Rep:78
kdramman will become famous soon enough
Default

Quote:
Originally Posted by robby5323 View Post
Can't get it to work on my 2012. Programmed it to my truck just like the video, but won't do anything. If I un-plug the unit and plug it back in I get a quick red and them a green for about 2 or three seconds. Then the light goes off. Nothing if I press the FOBs shows up...
Can't send PM's yet.

If you plug in the the harness to the DB-ALL and the green light comes on and then goes off, then the unit is programmed to your truck.

The DB-ALL doesn't flash the LED for anything except the remote start. Meaning that when you lock or unlock the doors, the LED doesn't flash. This is what troubled me when I first put mine in.

It's a little sensitive to the 3 distinct locks within 3 seconds. If the parking lights don't flash, then the DB-ALL doesn't see the signal.

I think your problem is that the unit is not set to RF-OUT. You can check by going into the programming mode of the DB-ALL.

This is in the DB-ALL manual on page 22, but I'll try and give you the steps.

1) Turn Key to on and then remove key.

2) Hold down the black button on the DB-ALL.

3) After 3 seconds the LED will turn orange then go off.

4) Let go of the button.

It will blink green to tell you which feature it is on, and then red to tell if it is activated or not.

RF-Out is feature 1- 1 blink green. On is 2 blinks red, off is 1 blink red.

You'll want it to blink Green, Red, Red......

To change the options you'll have to use the black 10 pin harness.

A pulse of the LOCK wire (green) to ground will change the option.

Let me know if that helps or not.
Reply With Quote