View Single Post
  #12  
Old 04-06-2012, 03:44 PM
InDeepWaterBlue's Avatar
InDeepWaterBlue InDeepWaterBlue is offline
Dodge Ram Forum Senior Member!

 
Join Date: Feb 2012
Location: Florida
Age: 27
Posts: 3,956
Gender: Male
Vehicle: 2011 Dodge Ram Big Horn
Trim Level: Big Horn
Color: Deep Water Blue
Engine: 2009-20?? 345ci (5.7L) Hemi V8 390hp 407lb/ft
Rep Power: 5
Rep:611
InDeepWaterBlue is a name known to allInDeepWaterBlue is a name known to allInDeepWaterBlue is a name known to allInDeepWaterBlue is a name known to allInDeepWaterBlue is a name known to allInDeepWaterBlue is a name known to all
Default

Installed the End links, fairly simple so there's no real install pics. Put the rear end up on jack stand to keep it as even as possible side to side, remove the OEM end links using an 18mm socket and wrench for the top. Use a 18mm wrench to loosen the bottom. To keep the ball joint from spinning, I use an adjustable or Vise-Grips. The instructions say use a 16mm, but they're wrong, go figure lol Now the new dog bone styled end link bolts can be installed using a 3/4 socket and wrench. Adjust the sway bar by rotating it up to line up with the holes and slide the bolts through to hold it in place. Tighten them up by had first then use a Torque wrench and tighten them down to 76Ft Lb's. That's it.

Comparison

Passenger Side

Complete
Reply With Quote